Disclaimer: I do not take any responsibility whatsoever if the information in this article causes you to damage your computer, or injure yourself.

Many universities and educational institutions ofthen throw perfectly good 19" monitors away, simply because the equipment they were attached to is obsolete. I picked up a perfectly good Sony GDM-1960 at an auction for $5. Here's the catch: most of them are fixed sync. Fixed sync means that they will only display one resolution. Most modern monitors are multisync which means they can display a plethora of different resolutions, including text mode, which is required at boot up, however...fixed sync monitors are incapable of text mode. Therefore, you should keep your multisync monitor along with the fixed sync monitor, possibly connecting them with a switchbox so you can alternate between the two when you need to.

Once you have acquired a fixed sync monitor, look at the back of it. It should have either three, four, or five BNC connectors labelled RGB, RGBS, or RGBHV respectively.

If you have 5 connectors, its pretty easy. Simply find a cable which goes from 5 BNCs to a standard VGA monitor connector (or make one), and set your computer to the monitor's proper resolution.

If you have 4 connectors, its a little bit harder. You have to see if your video card is capable of producing composite sync. Most ATI video cards support this. If you're not sure, try checking your manufacturer's website. If your video card supports composite sync, then find a cable that goes from 4 BNCs to VGA and set your resolution to the monitor's resolution.

If you have 3 connectors, it may require a bit of electronics experience. Your monitor is sync on green, which means it combines the sync signal with the green signal. The easiest option is if you have a video card which supports sync on green, such as the Matrox Millenium. If this is the case, simply set your video card to the correct resolution and select sync on green. If your video card doesn't support this standard, then you have two other options. The easiest is to get a sync on green adapter, which converts a standard RGBHV signal (which all PC video cards support) into an RGB sync on green signal. The last option is to modify your monitor. This is simple if you have a monitor such as a Sony GDM-1960, as I do, which can be modified to accept an RGBHV signal simply by soldering on 2 resistors and 2 jumpers. GDM-1960 modification instructions can be found at:
http://www.geocities.com/SiliconValley/Foothills/4467/fixedsync.html
WARNING: Do NOT remove the cover from a computer monitor or any kind of CRT display unless you know what you're doing. CRTs contain many large high voltage capacitors and chokes which can retain a voltage that can seriously injure you hours after the CRT is turned off. Please be careful.